iresq Posted September 17, 2008 Share Posted September 17, 2008 I should know the answer to this but am stumped.I have 2.0.16 installed. I have 'control lights' selected in play menu.When I attached the controllers, nothing. The enable option does not appear in the control panel, just enable shows.I can access the controllers through the hardware control. What am I missing?Additional info: led is solid, channels are correctly configured. Link to comment Share on other sites More sharing options...
Guest wbottomley Posted September 17, 2008 Share Posted September 17, 2008 Did you try going to edit, network preferences, choose the correct comm port for the regular network? Link to comment Share on other sites More sharing options...
iresq Posted September 17, 2008 Author Share Posted September 17, 2008 Yes, the comm port in the sequence editor is the same as the hardware utility. Link to comment Share on other sites More sharing options...
iresq Posted September 17, 2008 Author Share Posted September 17, 2008 Wow, do I feel like a boob.I was testing a short sequence using a newly assembled controller. I was only using the first 3 channels. Low and behold, I mis-labeled the cords. Of course I would have caught this had I of done proper testing.I blame Dan:P. His products have worked so well, I did not test the controller thoroughly. I made an assumption that certainly made an ass of me! Link to comment Share on other sites More sharing options...
Recommended Posts