keithandrews Posted November 26, 2018 Share Posted November 26, 2018 (edited) I need help in the HU I can make both controllers turn light on but in the SE editor on the unit 1 lights up unit 2 nothing if I swap units numbers the unit 2 to now 1 will still not light up . where should I look even swap to a different unit still nothing ? even moved cat 5 cables around ,tried 1 at a time , if 1 unit is running a different version software 1.09 rest are 1.06 would this be the problem ? Well I also tried to controller both 1.06 and nothing at least 1.09 controller worked Edited November 26, 2018 by keithandrews Link to comment Share on other sites More sharing options...
TheDucks Posted November 26, 2018 Share Posted November 26, 2018 Your sequence probably has a Network type or Network name set wrong In the SE, for each sequence: Tools: Channel Configuration: <look at each group>: Change Controller to adjust a SINGLE controller. Repeat for each that needs a nudge Link to comment Share on other sites More sharing options...
keithandrews Posted November 26, 2018 Author Share Posted November 26, 2018 1 hour ago, TheDucks said: Your sequence probably has a Network type or Network name set wrong In the SE, for each sequence: Tools: Channel Configuration: <look at each group>: Change Controller to adjust a SINGLE controller. Repeat for each that needs a nudge It's was a firmware update needed on controller thanks again all are up working now Link to comment Share on other sites More sharing options...
Recommended Posts