Helpusell Posted November 23, 2018 Share Posted November 23, 2018 I am doing something wrong and cannot figure it out. I bought a 3rd controller hooked it to the other two. When I do diagnostic it keeps saying found 2 units. I have hooked them up different ways and get the same answer. I am not thinking straight stressed. So it might be something simple I am not getting. Please help Link to comment Share on other sites More sharing options...
Speedster Posted November 23, 2018 Share Posted November 23, 2018 Your 3rd controller might have the same ID# as one of your first 2 controllers. You'll have to determine if this is the case and change the controller ID, I think via the Hardware Utility. My guess is your first 2 controllers have ID 1 and 2, and the 3rd controller that you bought separately is also ID 1. Link to comment Share on other sites More sharing options...
Dennis Laff Posted November 23, 2018 Share Posted November 23, 2018 Did you assign it an ID number Link to comment Share on other sites More sharing options...
Mr. P Posted November 23, 2018 Share Posted November 23, 2018 All controllers come from LOR as ID 1 so you need to connect it by itself and assign a new ID as you probably already have a 1. Link to comment Share on other sites More sharing options...
TheDucks Posted November 23, 2018 Share Posted November 23, 2018 Until you confirm (or set) the ID, only hook 1 controller. Do check the LED on the board. It needs to be lighting up (indicates power) and will be solid, when the network is recognized. Link to comment Share on other sites More sharing options...
Recommended Posts