Jump to content
Light-O-Rama Forums

Configuring pixel counts per port on Pixcon16


Recommended Posts

When I configured the Pixcon16 thru the NP util, I used the simple setup and told it that I had 100 pixels per port.  In reality, I use 50 pixels on some and 100 on the others.  Do I need to go back into the NP util to change that for each port or will the definition from the Sequencer work?  Thanks.


Edited by pouterson1
Link to comment
Share on other sites

  • The topic was locked
This topic is now closed to further replies.
  • Create New...