Mr.Fatboy6100 Posted September 7, 2018 Share Posted September 7, 2018 I have an existing DMX network that I use for stage lighting. I purchased a CTB16PCg3 to add some dimmable AC outlets. I am having trouble getting the controller to respond to any commands. Any set up I should know about? Using ADJ dmx controller if that helps Link to comment Share on other sites More sharing options...
Dennis Laff Posted September 7, 2018 Share Posted September 7, 2018 you have to use the lor /dmx conversion chart to give you the start address you need for dmx. Link to comment Share on other sites More sharing options...
k6ccc Posted September 8, 2018 Share Posted September 8, 2018 The other part is that “normal” DMX if using an RJ-45 connector, uses pins 1 & 2 while LOR uses pins 4 & 5. One tip to confirm wiring correct is that the LOR status LED on the PC board will be flashing if it is not receiving data and solid if it is receiving data. Link to comment Share on other sites More sharing options...
Recommended Posts