ajfelice Posted December 3, 2017 Share Posted December 3, 2017 i set the unit ID on the pixie 16 controller to # 2. so the unit ID's for the board should run 2-11 However, if I disconnect power and then replug in the pixie unit, When i refresh in HU it lists pixie as unit 1 again Any ideas? Link to comment Share on other sites More sharing options...
Mr. P Posted December 3, 2017 Share Posted December 3, 2017 If you have the new pixie, the one with the dip switches on the board then you need to turn them all off or to zero then set the ID with the HU. The switches override the HU ID when the pixie is powered down. Link to comment Share on other sites More sharing options...
ItsMeBobO Posted December 3, 2017 Share Posted December 3, 2017 Consider using an entire hex set. 10 to 1F. Gaps are ok. While you dont need 02-0A now, you may later. Link to comment Share on other sites More sharing options...
Recommended Posts