New pixel trees work, but nothing else

[Flyersc]

I bought two new pixel trees this year and sequenced them into all of my songs. After putting up my lights and 5 controllers, plus the trees, I can see all of them in the hardware utility. But when I run a show, only the trees work. All of the other lights don't do anything.

I have the trees at the end of the CAT5 cable run, going through the 5 other controllers first. Do I need to have the CAT5 cable going through the trees first? Or am I missing something else?

[TheDucks]

35 minutes ago, Flyersc said:

I bought two new pixel trees this year and sequenced them into all of my songs. After putting up my lights and 5 controllers, plus the trees, I can see all of them in the hardware utility. But when I run a show, only the trees work. All of the other lights don't do anything.

I have the trees at the end of the CAT5 cable run, going through the 5 other controllers first. Do I need to have the CAT5 cable going through the trees first? Or am I missing something else?

You probably have a speed issue. Pixies want 500K (the red usb adapter), Your old controllers are 57K.

 

You need to run  2 networks (or more). 1 HS (red) and another standard speed.  In addition, you CAN NOT mix (use) Enhanced mode devices  with the older standard mode on THE SAME NETWORK

[Flyersc]

Thanks for the reply. How do you run more than one network (comm port) on the same sequence?

[TheDucks]

1 minute ago, Flyersc said:

Thanks for the reply. How do you run more than one network (comm port) on the same sequence?

I opened the channel Configuration tool in the SE, Located the (track) controller on the list, click change controller, change the network value (the whole controller will change)

[Flyersc]

I see where you're talking about the Config tool in SE, but it doesn't list the pixel trees because they were created in PE. I don't see any way to change the controller in PE. Do you know?

[Dennis Laff]

You change the controller speed in   Network Preferances