Bird Posted November 26, 2016 Share Posted November 26, 2016 Long winded but diagnosed as well as possible Have 2 CCR arches and 3 -16 channel controllers. 3 controllers seem to behave properly. Both CCR's nothing. Exact same setup as last year. Have 5 extra CCR systems not in use yet. Swapped all items out, CCR controllers, net cable, power supplies, and ribbons. Same results on show computer and programming computer both of which have same sequence that worked last year. Did not copy sequences at all this year. 3 CCR controllers produce no lights on ribbons, 4 CCR controllers produce lights on only 1/2 of the ribbon. All controllers/CCR reset/test fine. Only thing not swapped out is USB485B, but again `6 channel controllers work fine. Thoughts or suggestions appreciated. Thanks, Bird Link to comment Share on other sites More sharing options...
ItsMeBobO Posted November 26, 2016 Share Posted November 26, 2016 Did you move any channels around? Did you change computers? Are you using the same USB485s as last year? Link to comment Share on other sites More sharing options...
ItsMeBobO Posted November 26, 2016 Share Posted November 26, 2016 Did you accidentally paste something into the macro channel area of your CCR in the sequence? Link to comment Share on other sites More sharing options...
Bird Posted November 27, 2016 Author Share Posted November 27, 2016 No channels moved around. No computer changes, Same USB495B as last year. Macro accident can happen but I would suspect not on both computers. I am completely perplexed by this problem. Link to comment Share on other sites More sharing options...
Marty Belisle Posted November 29, 2016 Share Posted November 29, 2016 Did you happen to upgrade your license or are you using pixel editor to sequence this year? If so you may need to update the firmware on your CCRs and ensure CCRs are set up as enhanced. If you plan to run enhanced 500k you will also need a high speed USB adaptor (little red one). Not sure what generation your controllers are however older models may not run with an enhanced network. Looks like you are adding some CCRs so it may be best to separate your pixels to a dedicated network anyway. Link to comment Share on other sites More sharing options...
SnappyTom Posted November 28, 2017 Share Posted November 28, 2017 Do you have One or two networks setup? Are all the lights on your controllers solid red? Link to comment Share on other sites More sharing options...
Recommended Posts