Jump to content

LOR Crashes when trying to load sequences


Art
 Share

Recommended Posts

 I bought a new drive and cloned the data from the old drive.  Now when I open LOR on the new drive it crashes when i try to open an old sequence or try to start a new one. I reconnected the old drive and everything works.  Any suggestions.

 

Art

Link to comment
Share on other sites

What error message (if any) do you get?

 

Link to comment
Share on other sites

What operating system,and what LOR version?

 

Link to comment
Share on other sites

running windows 10.  The error is something like " the program has stopped responding  closing program".  Also I even tried to reload the LOR program with the newest verison and it still happens.  Again I  can put the old  drive back  in and all  is well.  Just issues when I try to run the program on the newly cloned drive, but everything else runs on the newly cloned drive.

 

Art 

Link to comment
Share on other sites

Don't have a good answer to that one.  You should likely open a ticket with LOR on this.

 

Link to comment
Share on other sites

You may have to clean out the old LOR files, registry and etc...then reinstall. I think LOR has a utility that will do this but please don't hold me too  that. I remember reading something about it a while back.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...