Jump to content

CCB100 V1.21 last string on last controller not working


Recommended Posts

Looking for some help. I have 5 CCB100's all running on Enhanced 500k network and the very last strand (string 2) of the last controller will not work. I have swapped string 1 and 2 around and string 2 begins to work just fine and string 1 goes out. So it is not a problem with the strand of lights itself it just seems to be whatever is last in line will not work. I have updated all of my controllers to the lastest firmware 1.21 as well as the Sequencing suite. Any help would be great. Thanks!

Link to post
Share on other sites

You have 5 CCB's.  Are you sequencing them as units 1/2, 3/4, 5/6, 7/8, 9/10?  If so, the last one is not 9/10, it is 9/0A.  You need to change your sequencing from unit 10 to unit 0A.  I initially made this mistake.

Link to post
Share on other sites

Thanks for the reply. Maybe I have them setup wrong. I currently have them set up as Units 4-5-6-7-8. In the sequence editor they are set up as CCD 04 s1 (circuit 1-50) AND CCD 04 s2 (circuits 161-310). The other four are set up the same way but with the different unit ID's.

Link to post
Share on other sites

You're OK.  There are several ways of setting up CCBs.  The way Rayburn described it is "Dual Normal", and you are using the other way "Normal".  Just make sure that the CCBs are all set up to be in "Normal" mode.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...