Jump to content
Light-O-Rama Forums

Single Controller Flashes Channels When Not Supposed To


Recommended Posts

I have a single controller that runs all of the circuits attached on twinkle when they are not supposed to be on.  I have triple checked the programming and it is not a programming error.  It seems to be doing it after I have them programmed to twinkle during an announcement.  It's almost like they get stuck on twinkle.  Once the next command goes through, it goes off twinkle and does what it is supposed to.  I also have a CCR that does this.  I am wondering if it's not a bad network cable.  Any suggestions?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...