Jump to content
Light-O-Rama Forums

Made some low profile mounts for controllers


plasmadrive

Recommended Posts

I like those very much but unfortunately where I am from those would be covered in snow lol...

Link to comment
Share on other sites

I like those very much but unfortunately where I am from those would be covered in snow lol...

ha ha.. no snow here..

Link to comment
Share on other sites

There is a rough drawing in there now.

"Rough" ?

Those are freakin cad quality drawings.

Most of my sketches for props are sharpies on cardboard.

Link to comment
Share on other sites

"Rough" ?

Those are freakin cad quality drawings.

Most of my sketches for props are sharpies on cardboard.

LOL.  Thanks..  I am a sparky not a mechanical eng.    I know there has to be lots missing from that drawing.... So to save face.. I say "rough".   (it is a CAD drawing BTW, I am just not that good at it)

Link to comment
Share on other sites

Very nice but I'm like circleracer & they would end up under 3' of snow.

 

Most of my sketches for props are sharpies on cardboard.

 

I use crayons on toiletpaper!!

It's usually the only thing I have on hand when I'm on my porcelain thinking chair.  :blink:

Link to comment
Share on other sites

Very nice but I'm like circleracer & they would end up under 3' of snow.

 

 

I use crayons on toiletpaper!!

It's usually the only thing I have on hand when I'm on my porcelain thinking chair.  :blink:

Those are of course West Coast mounts...

Doesn't your stuff wind up under snow anyway? 

Link to comment
Share on other sites

Those are of course West Coast mounts...

Doesn't your stuff wind up under snow anyway? 

 

By the time I shut down for the season you can barely see half of my 3' candycanes or minitrees.

 

2015-02-07%2015.56.06.jpg

 

I think I've posted this pic before.

Gotta love Canada!!

Link to comment
Share on other sites

  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...