Jump to content

status light


ken collins
 Share

Recommended Posts

ran into a problem (I think) when resetting my boards, when I set them to zero, got 2 quick blinks and a pause, cycled over and over. I didn't recall seeing that before, so I quit and thought I'd throw it out and see if anybody else has run into that pattern

Link to comment
Share on other sites

LightORamaDan

That is the correct behaviour...

for everone: When resetting a controller and you see the quick blink only do it for a few seconds. Do not allow the controller to sit there in that reset state for a long peorids of time (like minutes) or the micro-computer can be damaged.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...