Lagging Prop

[Randy Campbell]

I have (4) arches set up. For some reason one of the arches only moves half the speed as the other three arches when running a (red to blue) morph, although all four have the same timings and settings. A few seconds later when the sequence switch colors, (red to white) the arch then move as the same speed as the other 3 arches.  Keep in mind the arches are moving fast. Any idea what would cause this or how I can correct it? I've attached a photo of the settings for the normal morph.

[Randy Campbell]

I was going to post the setting for the slow arch too, but i don't have enough download space. The only difference between the 1st arch and 3rd arch is the X,Y settings are 2-0 and 2-49. Thanks.

Edited August 22, 2015 by Randy Campbell

[BrianBruderer]

The speed of the morph should depend on the time length between the start time and end time and the number of pixels between the start position and end position. The size of the head can make the morph "linger" and may cause it to appear to be slower.

 

Check If both of the morphs:

1) have the same time length between the start time and end time

2) have the number of pixels between the start position and end position

3) have the same head length for state 1 and state 2.

[Randy Campbell]

A simple mistake, I was looking in the wrong area. Thanks again for your help.