SPT cords

[shfr26]

For the last few years I have used the same cords for my mega tree.  This year I want to move them to a different display element.   Since I have the controllers recognized in the HU and the cords have been recognized as going to that controller,  do I have to still use them for the mega tree and buy new ones or do I have to plug them into the new display and then run the HU again so they are seen as the new element and not the mega tree?

 

           Thanks in advance.

[k6ccc]

<deleted>

Edited June 15, 2015 by k6ccc

[George Simmons]

I think you need to buy/make new cords. Re-assigning them in the HU is certainly doable but it can be such a pain in the ask that it's probably simpler and quicker to just replace them and be done with it.

[Don]

For the new folks around here, just ignore this thread.

 

These gentlemen are out to pull your leg and play a joke on people. Please don't assume this is correct information. You don't assign cords to anything via software.

[TGabriel]

Bad day for fishing

[shfr26]

For the new folks around here, just ignore this thread.

 

These gentlemen are out to pull your leg and play a joke on people. Please don't assume this is correct information. You don't assign cords to anything via software.

Well, well, well.  I never said software.  If we can not have any fun, then why are we here??   And by the way, ignore Don 's post, he has no sense of humor

 

      I  knew the cords did not matter but figured I would start a haha thread.

If you thought I did not know that, well I have done this for a few years and was just tryng to have a little fun, but as usual,  Big daddy Don has to step in and take all the fun out of it.

Edited June 15, 2015 by shfr26

[Old Sarge]