Mike Heatherly Posted December 14, 2007 Share Posted December 14, 2007 I have two controllers the ctb16d is unit 1. The 16 channel pc board is unit 2. When I run through a song all 32 channels are coming on to unit 2. I checked all my channel addresses and everything looks right. I have only had the ctb16d as unit 1, I will mention that the hardware utility has never been able to identify this board. Dan told me that should be ok as long as it still controls the lights, which it did when I hooked it up by itself and ran it through a song to check it. I am obviously doing something wrong and am looking for suggestions.Mike Link to comment Share on other sites More sharing options...
cmoore60 Posted December 14, 2007 Share Posted December 14, 2007 A few of things come to mind.Try a board reset on your board 01.Second, IF the reset does not work, then try setting board 01 to some other address, something like 04. There is nothing that says controllers have to be assigned in sequencial order.Make sure after you set the switches for the address, that you cycle power.Chuck Link to comment Share on other sites More sharing options...
Guest wbottomley Posted December 14, 2007 Share Posted December 14, 2007 Check your channel config too. Link to comment Share on other sites More sharing options...
Recommended Posts