m3chris Posted December 12, 2014 Share Posted December 12, 2014 (edited) I did 8 rgb channels last year and have added a second cmb24d. I was assuming I just do cat 5 out and into the second one. I assigned controler 2 with channels 1-24 Im thrown off as I am running a sequence from last year with only 8 rgb channels and all my new lights are doing stuff that are hooked up to the new board that should be unit 2 and I have not sequenced yet. chris Edited December 12, 2014 by m3chris Link to comment Share on other sites More sharing options...
Don Posted December 12, 2014 Share Posted December 12, 2014 I did 8 rgb channels last year and have added a second cmb24d. I was assuming I just do cat 5 out and into the second one. I assigned controler 2 with channels 1-24 Im thrown off as I am running a sequence from last year with only 8 rgb channels and all my new lights are doing stuff that are hooked up to the new board that should be unit 2 and I have not sequenced yet. chris The CMB24D address is set with dip switches that are on the board. Check the user manual for the settings for each LOR address. If you set the address in the Hardware Utility (HWU) then you really didn't set the address. Link to comment Share on other sites More sharing options...
m3chris Posted December 12, 2014 Author Share Posted December 12, 2014 Perfect! Thank you. Link to comment Share on other sites More sharing options...
Recommended Posts