Gilles Posted November 25, 2014 Share Posted November 25, 2014 Hardware Utility found CMB24D with the right unit id. I hook up two lights to test and everything is good. However, it won't play when I play my sequence. Where should I look to find the problem? Link to comment Share on other sites More sharing options...
Dennis Laff Posted November 25, 2014 Share Posted November 25, 2014 Check your sequence for the proper channel configuration and make sure controll lights is on Link to comment Share on other sites More sharing options...
Gilles Posted November 25, 2014 Author Share Posted November 25, 2014 I don't understand what you mean by control lights is on. Is there a switch?I hook up CMD24B board to the adapter by cat5, adapter to my laptop. Link to comment Share on other sites More sharing options...
George Simmons Posted November 25, 2014 Share Posted November 25, 2014 It's an option in the Sequence Editor under the PLAY heading. Link to comment Share on other sites More sharing options...
Gilles Posted November 25, 2014 Author Share Posted November 25, 2014 Nope, nothing happens. Link to comment Share on other sites More sharing options...
Gilles Posted November 25, 2014 Author Share Posted November 25, 2014 Never mind. They work now. Link to comment Share on other sites More sharing options...
Don Posted November 25, 2014 Share Posted November 25, 2014 Nope, nothing happens. Never mind. They work now. Can you tell us what the problem was? Link to comment Share on other sites More sharing options...
Gilles Posted November 26, 2014 Author Share Posted November 26, 2014 Don: The control lights option and my laptop. If I run the sequence for the flood lights ny itself then it is fine, but if I intergrate this section into my main sequence with so many other rgb channels then the lights won't lit up. Link to comment Share on other sites More sharing options...
Recommended Posts