Ukwild Posted November 15, 2014 Posted November 15, 2014 I am new and i cant get there hardware utility to find my cmb24 board, in the comm port it states 1 device found but then when searching in the 'select a unit to configure' it finds no devices, i have checked the lor/dmx jumpers, i have checked the unit id jumpers, so i am out of ideas, also one other thing to mention is the red led on the board is on solid,
Dennis Laff Posted November 16, 2014 Posted November 16, 2014 When the hardware utility finds it does the ID# match the ID # you set it to
Rayburn Posted November 16, 2014 Posted November 16, 2014 I believe the CMB24 is addressed via dip switches and not the HWU.
Don Posted November 16, 2014 Posted November 16, 2014 Try a reset of the controller. To set all device parameters back to factory defaults and erase any stand-alone program, power the controller down, set DIP switch 12 to ON and power it up. The Status LED will flash quickly. Power the controller down and turn DIP switch 12 off. Reset the dip switches to your desired value. Make sure that the number in the top right of the Hardware Utility is higher than that of the address you chose for the CMB.
Recommended Posts