Dan Maslyk Posted November 27, 2007 Share Posted November 27, 2007 I've read to reset a controller you do the following:1. Power off, set unit ID to "00", Power ON (led blinks fast)2. Power off, set Unit ID back to original value, Power onHow do you do this for the CTB16PC, where the address is set in software? Link to comment Share on other sites More sharing options...
Tim Fischer Posted November 27, 2007 Share Posted November 27, 2007 Dan Maslyk wrote: I've read to reset a controller you do the following:1. Power off, set unit ID to "00", Power ON (led blinks fast)2. Power off, set Unit ID back to original value, Power onHow do you do this for the CTB16PC, where the address is set in software?I think that removing the jumper on J0 is the equivalant of "00" on those boards. You then replace it once it's reset.Someone who actually owns one should probably confirm...-Tim Link to comment Share on other sites More sharing options...
Push Eject Posted November 27, 2007 Share Posted November 27, 2007 Tim is right.Power down. Take the jumper off J0. Power up. The LED will blink twice then pause signifiying the controller is resetting.Power down. Replace jumper. Do the "Any Unit" > "New ID" dance.Cheers,Charlieedit for spelling 1 Link to comment Share on other sites More sharing options...
fire_paramedic Posted November 28, 2007 Share Posted November 28, 2007 Push eject is absolutely correct,I would only add, make sure you put the jumper back on the same pin set. 2nd set down from top. it would cause it to constantly reset if it is not in the right place, and maybe other problems as well. Link to comment Share on other sites More sharing options...
Recommended Posts