ditzel Posted November 13, 2014 Share Posted November 13, 2014 HiIm having trouble with getting my ccr to only half work in the hardware utility, as if you where doing arches with them I have followed the manual, but the only thing I cant do is, is get the CCR config button to work Link to comment Share on other sites More sharing options...
PaulXmas Posted November 13, 2014 Share Posted November 13, 2014 Not sure if you can get the CCR to working the HWU.Try out one of your sequences to test it. Link to comment Share on other sites More sharing options...
steve synek Posted November 14, 2014 Share Posted November 14, 2014 There is a limit to the number of pixels you can control with the hardware utility. You have to select extended control at the bottom of the screen somewhere. Than you have to re-enter the controller ID. There is a slide bar to move through groups of pixels for testing. Steve Link to comment Share on other sites More sharing options...
dgrant Posted November 15, 2014 Share Posted November 15, 2014 If you look in the CCR manual that came with it/them, it'll explain how to access and test all of channels on the CCR. Steve is correct...you must select the Extended button, then the address, then the horizontal slider to get it to channels 145-161 or something like that, then use the vertical sliders. These command the macro functions to the CCR itself so use the manual! Link to comment Share on other sites More sharing options...
Recommended Posts