Jump to content

S3, Matrix Sign, Visualizer, Vegomatic and Marquee


Recommended Posts

I have a 10x17 (170) pixel matrix sign I have just made. Hopefully I have not messed up with the design. I looked over at the Holidaycoro site and saw where David suggested that the pixels go right to left pattern. I did not do that. I went up and down from the right corner going left. Hopefully I have not messed up. I know this topic is under the "Software" side of things so here we go (again if I have not messed up on configuring the pixels).

 

How do I get the above mentioned pieces of software configured correctly to reflect my pixel layout? Also when exporting it, how can I label the channels in S3 without having to go and type in changes on all 510 channels?

 

Thanks,

Robert

Link to post
Share on other sites

Hey Bob.

Thanks for the response and btw thanks for all your software development and what you do for the community!

 

Ok. I have Vegomatic 17 strings and 10 RGBs. Controller is on the bottom right...looking on the backside. So the software has it marked as the right bottom.

 

Is that correct then?

Link to post
Share on other sites

Ok. Changed the controller point. Also have been able to export out and then import in the .lcc file. However it overwrites the 1st track and takes out all of the RGB settings for the tracks below.

Running the latest LOR software with the advanced license.

Link to post
Share on other sites
Guest
This topic is now closed to further replies.
×
×
  • Create New...