ndiaz Posted November 23, 2007 Share Posted November 23, 2007 I have a pc bord, LOR recently sent me a replacement Processor chip to fix this one, but now, channels 1-8 dont want to work.I've updated the firmware, changed the Unit ID, and made sure the channels are set-up. I've done all I think I can do, anything else? Link to comment Share on other sites More sharing options...
Randy Posted November 23, 2007 Share Posted November 23, 2007 Hi Nick,How are you routing power to the board? Just one power cord? Do you have the jumpers between the two sides in place?Just a thought (cuz it happened to me today!)...Randy Link to comment Share on other sites More sharing options...
ndiaz Posted November 23, 2007 Author Share Posted November 23, 2007 Randy, I'm using 2 inputs, and the led blinks so that means the power is going to both sides, I think. Link to comment Share on other sites More sharing options...
cmoore60 Posted November 23, 2007 Share Posted November 23, 2007 The LED blinking is a indication that the right side (channels 9-16) have power. The fuse is good on that side of the baord. Since you do not have channels 1-8, I would suggest you check the fuse on that side of the board.Chuck Link to comment Share on other sites More sharing options...
ndiaz Posted November 23, 2007 Author Share Posted November 23, 2007 Okay, I'll try that, THanks. Link to comment Share on other sites More sharing options...
Randy Posted November 23, 2007 Share Posted November 23, 2007 If you need replacement fuses, Radio shack has them. The part number for 15 amp fasting fuses is 270-1040 and they come 4 to a package.Randy Link to comment Share on other sites More sharing options...
ndiaz Posted November 23, 2007 Author Share Posted November 23, 2007 Thanks Randy, Just went out there, The fuse works in another bord, so I don't think its that. Link to comment Share on other sites More sharing options...
LightORamaDan Posted November 24, 2007 Share Posted November 24, 2007 ndiaz wrote: Thanks Randy, Just went out there, The fuse works in another bord, so I don't think its Nick,Check to make sure that when you put the chip in that a pin was not bent under and is not making contact.Dan Link to comment Share on other sites More sharing options...
Recommended Posts