ItsMeBobO Posted September 15, 2014 Share Posted September 15, 2014 (edited) Two servos each controlling four connected floods. Mounted on the ceiling in my lights workshop. Edited September 15, 2014 by ItsMeBobO Link to comment Share on other sites More sharing options...
Santas Helper Posted September 15, 2014 Share Posted September 15, 2014 That's pretty cool Bob!!! Thanks for sharing. Link to comment Share on other sites More sharing options...
larryk5 Posted September 15, 2014 Share Posted September 15, 2014 That is just to cool! What servo did you use? Link to comment Share on other sites More sharing options...
crackchecker Posted September 15, 2014 Share Posted September 15, 2014 are you using servodog or just DGB to run the servo? Link to comment Share on other sites More sharing options...
ItsMeBobO Posted September 15, 2014 Author Share Posted September 15, 2014 DIO32 board has servo control for up to 16. I have been using this board with a daughter relay board for my strobes and drip tubes for three years. This is my first servo project so I am by no means certain I picked the correct parts. This is just my solution until it fails and I find it needs improvement. Hitec HS-5495BH Digital Standard High Voltage Servo. This one needs a 7.4vdc psu which caused a delay in my project. I didnt say in the video that all the wood parts are oiled but the servo is not water resistant. I am hoping to arrange a little cover to keep drips off of them. Link to comment Share on other sites More sharing options...
Recommended Posts