Meegan Posted August 1, 2014 Share Posted August 1, 2014 How do you make 90 turns with CCR ribbon? These seem limited based on design. After all the tips I've seen out there, there has to be a work around for this.Thanks in advance Link to comment Share on other sites More sharing options...
Dennis Laff Posted August 1, 2014 Share Posted August 1, 2014 cut and solder Link to comment Share on other sites More sharing options...
Meegan Posted August 1, 2014 Author Share Posted August 1, 2014 Thanks for the feedback. Do you then just slap on Some sort of RTV to seal and weatherproof? Link to comment Share on other sites More sharing options...
steve synek Posted August 1, 2014 Share Posted August 1, 2014 I cut and soldered jumpers between the cuts and put silicon on the splices. The bad news is that cutting the ribbon voids the warranty. If I had to do it over again, I would consider using CCPs. Steve Link to comment Share on other sites More sharing options...
Meegan Posted August 1, 2014 Author Share Posted August 1, 2014 Thank you! Good tip AND good warning. Will give that some thought Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now