Jump to content

Panic on a CTB 16 PC


Dan Maslyk
 Share

Recommended Posts

I just finished my second CTB16PC and I am now in full panic mode. Plugged in the unit and the LED is flashing. When I plug in the Cat 5e the light goes solid. But when I try to initialize in Hardware it doesn't find it "0 found".

Link to comment
Share on other sites

You're plugging it in by itself, right? Selecting Any Units in previous id?

Edit: "any" was "all"

Link to comment
Share on other sites

Perhaps you need to assign its ID. In the hardware utility under Old Unit ID select Any Unit and under New Unit ID pick whatever number you want it to be (e.g. "1").

Let 'er rip then see what you find when you scan your network.

Charlie

Link to comment
Share on other sites

I'm using two 16PCs this year for the first time and getting used to the software assigned IDs too.

Cheers!

Link to comment
Share on other sites

I had the same problem with 4 PC units this year. I remembered from last year that in the hardware utility on the left of the screen it had ID's and these units did not. So I thought why not and configured them, 3, 4, 5, 6 and then plugged them all in and clicked refresh and BAM! there they are. I did need to update the harware utility so I could see what software versions these were running. All's ok now. :)

Link to comment
Share on other sites

LightORamaDan

CTB16PC cards are delivered without a Unit ID. You have to set the ID with the Hardware Utility

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...