fire_paramedic Posted November 28, 2007 Share Posted November 28, 2007 JSt checking to be sure. has the other board been reset also ans set with unit 2 or something other than 1, i belive the software set ones using the hardware utility default as 1. Link to comment Share on other sites More sharing options...
Mike Heatherly Posted November 28, 2007 Author Share Posted November 28, 2007 When I hooked up the pc board I gave it the address of 02 because that one was going to be setup as unit 2 when I get it all hooked up. Link to comment Share on other sites More sharing options...
fire_paramedic Posted November 28, 2007 Share Posted November 28, 2007 whoops clicked when i should have typed.misposted Link to comment Share on other sites More sharing options...
fire_paramedic Posted November 28, 2007 Share Posted November 28, 2007 I would try contacting LOR and see what they can tell you, i know they are busy now but i am out of ideas and it sounds like a logic/Data circuit problem with the board now. They would be better at troubleshooting that. Sorry.. Link to comment Share on other sites More sharing options...
Mike Heatherly Posted November 28, 2007 Author Share Posted November 28, 2007 fire_paramedic wrote: I would try contacting LOR and see what they can tell you, i know they are busy now but i am out of ideas and it sounds like a logic/Data circuit problem with the board now. They would be better at troubleshooting that. Sorry..Thanks for the help. It looks like you have been putting out some fires all over the board. (pun intended). I have an e-mail into support but I'm trying to work it from other areas as well.Mike Link to comment Share on other sites More sharing options...
Recommended Posts