Jump to content

Moved Jumper J0 down one on the 18pin


bowenrichard
 Share

Recommended Posts

I could not get my ID to set so I thought I was suppose to move the jumpers. I moved the J0 pin down one and found that it did not help so I moved it back. Now I have no communication or detection in the hardware utility. I have ruined the controller or is there a way to reset it?

Red LED is blinking none stop

Link to comment
Share on other sites

LightORamaDan wrote:

...he burned out the comm chip...

Now THAT, my friends, is a REAL man!
Link to comment
Share on other sites

LightORamaDan

Push Eject wrote:

LightORamaDan wrote:
...he burned out the comm chip...

Now THAT, my friends, is a REAL man!


Mr. Push Eject.... I must say, you made me laugh! (you are nuts:))

Dan
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...