Guest guest Posted January 15, 2006 Share Posted January 15, 2006 Hello,I just got things going last night for the first time. I ran a few sequences here and there to test the LORs and some lights I strung up for practice. Before, during and after I ran sequences, a couple light strands/channels would fade on then off then going to a couple other strands/channels doing the same thing.If there was something about this previously mentioned, Sorry, I must have overlooked it.Any thoughts?Thanks, Tom Link to comment Share on other sites More sharing options...
Guest guest Posted January 15, 2006 Share Posted January 15, 2006 Sounds like there is a standalone seqence running in the controller. What type of controller are you using? Link to comment Share on other sites More sharing options...
Guest guest Posted January 15, 2006 Share Posted January 15, 2006 It's 2 LOR16s.Would the standalone still function if the computer is running the show?Thanks DanTom Link to comment Share on other sites More sharing options...
Guest guest Posted January 15, 2006 Share Posted January 15, 2006 Santas Helper wrote: It's 2 LOR16s.Would the standalone still function if the computer is running the show?Yes it would.... Reset those units as follows:Unplug / Set unit ID to "00" / Plug back in for at least 5 secondsUnplug / Set unit ID back to original value Link to comment Share on other sites More sharing options...
Guest guest Posted January 15, 2006 Share Posted January 15, 2006 Thanks Dan, I think that did the trick. Now back to the other forum.Tom Link to comment Share on other sites More sharing options...
Recommended Posts