jamesssydney Posted January 29, 2014 Share Posted January 29, 2014 Evening All I'm having an issue getting a WS2811 strip of 22 pixels 66 channels to work. I can get the small strip to work independatley LOR. Window 7 professionalECG-P2 connected via ethernet cable to back of mode,Running LOR 3.10.12LOR controll panel is opened first before opening sequencerLOR status = disabled also connected to DMX listenerComm port open (see attached image)Control lights selected under play tab.Wirless internet switched off I am getting a comm port status error ( see attached image) I've use the ECG-P2 with no issues before Not sure what else to check? Look forward to hearing from you. Kind regards Link to comment Share on other sites More sharing options...
MCas4380 Posted January 30, 2014 Share Posted January 30, 2014 Is you USB485 plugged in? This will tell the software to send a signal. You don't need to hook a controller to it just the USB485.Hope that's helps Link to comment Share on other sites More sharing options...
Dennis Laff Posted January 30, 2014 Share Posted January 30, 2014 (edited) Did you set your network To E1-31 Edited January 30, 2014 by Dennis Laff Link to comment Share on other sites More sharing options...
Recommended Posts