nmonkman Posted November 30, 2013 Share Posted November 30, 2013 I had set up my new green board controllers with ID #'s 13, 14 15 respectively. Everything was fine. Tonight I went to test lights and it cannot find #15. I am scheduled to start my show tomorrow. Any expedited help would be appreciated. I will be outside until this is resolved or until all other lights are tested. FEEL FREE TO CALL MY CELL 239-462-7371 Thanks in advance for any help Link to comment Share on other sites More sharing options...
nmonkman Posted November 30, 2013 Author Share Posted November 30, 2013 Figured it out. Put the controller back on the bench under my hubble telescope. Turns out two of the pins on the 8 pin just to the left of the RJ45 plug were broken. Only half the pin was there so it was barely touching. No time to order a new one so I had to lightly solder. Link to comment Share on other sites More sharing options...
Recommended Posts