Jump to content
Light-O-Rama Forums

Problem with MIni Director


litnup

Recommended Posts

Last night I started my Halloween show and during the show my Mini Director stopped working and the light on the unit went off. So I went to unhook the CAT 5 from the LOR board and the light on the board started blinking and when I plugged it back in it started to blink fast and then went out. This only happened when I had the Mini director with the SD card attached to the system..............Any ideas on what this could be?

Link to comment
Share on other sites

Use your USB adapter, connect it to the mini director, open the hardware utility, and see if the mini director is recognized.

Link to comment
Share on other sites

I think you need to go into the hardware utility to the LOR control tab, and under setup comm port select auto configure, then after it finds the comm port go into the select unit to configure, click refresh and see if it recognizes the mini director.

Link to comment
Share on other sites

I had the same problem with my Mini Director i had end up replacing the unit , it had an internal failure and could noy be repaired, also it was an older unit approx 4 to 5 years old. 

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...