shookemup Posted October 7, 2013 Share Posted October 7, 2013 when i try to enable a sch. i get a 8002 error code Link to comment Share on other sites More sharing options...
Don Posted October 7, 2013 Share Posted October 7, 2013 This happens when your USB adapter is not connected. Connect the USB adapter, and you'll be okay. Link to comment Share on other sites More sharing options...
shookemup Posted October 7, 2013 Author Share Posted October 7, 2013 Everything works in sequence editor, so everthing is working properly or hooked up. But only when I try to enable the sch. it flips out and gives me the 8002 comm error code... Link to comment Share on other sites More sharing options...
Don Posted October 7, 2013 Share Posted October 7, 2013 Close all LOR programs, and open the LOR Hardware Utility. You are going to get the same error. Either you do not have the USB485 adapter connected, or LOR doesn't know where it is. If it doesn't know where it is, it can't enable the shows. The Sequence Editor does not need a USB485 adapter connected for it to function properly. You can run the SE with or without an adapter installed. The fact that the SE runs without a USB485 installed does not indicate that everything is working properly. Link to comment Share on other sites More sharing options...
Recommended Posts