Nick Harpold Posted October 4, 2013 Share Posted October 4, 2013 I'm sure I'm missing something simple but the Hardware utility will not find my ccr controllers when they are daisy chained. I am using Comm 4 for an AUX. Network. I have Comm 3 assigned for my regular network that will run 6 regular LOR controllers, Comm 4 will be Aux. network A with 6 CCR's, and Comm 5 will be Aux. network B with 6 CCR's. This is the first time I have hooked up more than 1 CCR at a time. I select comm 4 and refresh and it shows 0 controllers. So I checked for them individually and it recognized all 6. Each with the correct unit id 07-OC. I started over just hooking up unit 07 it was found. I added unit 08. It was found along with 07. When I added unit 09 to the 07 and 08. The Hardware utility would not find any of them. Like I said I'm sure I'm just over looking something simple. Hopefully someone can get me pointed in the right direction. Thanks, Link to comment Share on other sites More sharing options...
Don Posted October 4, 2013 Share Posted October 4, 2013 If you are planning to use to 500k, make sure that the firmware on all ccr controllers is updated to the most recent version. If not running 500k then make sure that you don't accidentally have the 500k setting chosen for the ccr networks. Link to comment Share on other sites More sharing options...
Nick Harpold Posted October 4, 2013 Author Share Posted October 4, 2013 All controllers have been updated to the latest firmware. 500k is selected on all of them. Link to comment Share on other sites More sharing options...
Nick Harpold Posted October 4, 2013 Author Share Posted October 4, 2013 Figured it out. Just a bad Cat5 cable. Thanks for the help Don.... Link to comment Share on other sites More sharing options...
Recommended Posts