calypso11 Posted September 28, 2013 Share Posted September 28, 2013 im outlining my house in rgb , peek 1 (176 pixels) . peek 2 (111 pixels) , peek 3 (177 pixels) , peek 4 (162 pixels) , above garage (196 pixels) , 4 going up the sides 2 @(137 pixels) , 2@ (83 pixels) my question is I bought some sequences from creativelightingdisplays and I want to transfer them over , I already made up a few of my own in superstar and transferred into the sequencer for my arches but getting a little confused with the out line because it will only let me do 170 channel max , I have e682 controllers not sure what im leaving out but not sure where to ask thank you in advance dan Link to comment Share on other sites More sharing options...
calypso11 Posted September 28, 2013 Author Share Posted September 28, 2013 im also curious to see how I put peek 1 I cluster 1-1 peek 2 in cluster 1-2 ect.. and make work Link to comment Share on other sites More sharing options...
bisquit476 Posted September 28, 2013 Share Posted September 28, 2013 Here is a link to something that will help you understand RGB, you will need to register though to download it, hope this helps, http://auschristmaslighting.com/forums/index.php/topic,1889.0.html Link to comment Share on other sites More sharing options...
calypso11 Posted September 28, 2013 Author Share Posted September 28, 2013 thank you , over the last week ive learned a ton by post and reading that info sheet ect... I cant seem to get all 4 clusters working together if I separate them into different universes they work any suggestions? Link to comment Share on other sites More sharing options...
Max-Paul Posted September 28, 2013 Share Posted September 28, 2013 thank you , over the last week ive learned a ton by post and reading that info sheet ect... I cant seem to get all 4 clusters working together if I separate them into different universes they work any suggestions?Could you be a bit more descriptive of what you mean by cant get them to work. What are they doing or not doing while in a single cluster? I had a mere 50 nodes in a single cluster and the last 12 or so were fluttering, would not remain on solid as programmed. Seems that I was using to small of a wire gauge to carry enough current. Thus a voltage drop. I took the cheap way out and now have 25 nodes on one cluster and 25 on another. I would later wish to put them all back on the one cluster leaving a spare cluster / outlet on my E6804 controller. So, depending on what you mean by not working. It might be the length or undersized wire that is causing you problems. Link to comment Share on other sites More sharing options...
calypso11 Posted September 28, 2013 Author Share Posted September 28, 2013 im wiring up left over strands in basement , I put 2 separate strands in and put it an sat 100 pixels and press play and will only play 1strand , per say I want to put 2of my peeks in one cluster group 1-1 -1-2 , im just a bit confused and think im going to have a lot of wasted space on controller if I use 1 universe per peek and sides that's 9 separate universes im very green with rgb thank you for your ptience Link to comment Share on other sites More sharing options...
Recommended Posts