Ralph D Posted August 21, 2013 Posted August 21, 2013 So I have a lot of thoughts on this but ill wait until later, how do you think they look http://youtu.be/kIyrbqAj_sY
Ron Boyd Posted August 21, 2013 Posted August 21, 2013 Very nice. How did you end up doing them? Did you use the PEX or what? Good job my friend
Ralph D Posted August 21, 2013 Author Posted August 21, 2013 So i have some issues with the arches and ccp pixels. because there ccp's are not laying flat on the tubing I'm using, so i was trying to come up with ideas to attach something to the length of the ribbon through the tube and then connected at the end of each part of the tube, it would have to be something sturdy enough to keep the ribbon from twisting as it goes through the tube, yet flexible enough to bend with the curvature of the arch. My idea was to get a very very thin piece of balsa wood hot glue it to the bottom of the pixel ribbon and connected at the ends of my tubing. Might anyone else have any other ideas. There has to be something that's very thin bendable but sturdy enough to keep the pixel ribbon from twisting on its own. Ron, sent PM
Recommended Posts