Jump to content

Sequence Editor errors out when attempting to run


Philip
 Share

Recommended Posts

Been using the sequence editor for some time now with no problems, I do have the full paid version 1.6.3, but when I went this morning to run the program I get the error ... "Component LORChannelIO.ocx or one of it's dependencies not correctly registered: a file is missing or invalid"

Then when you click ok, it just goes away. I had been getting an error about not having a valid comm port but wasn't worried about it because this isn't the pc I use to "run" the light show

Link to comment
Share on other sites

Steppe Wolfe

The standard technician questions...
Have you rebooted?
Have you installed anything recently?
Is windows restore active and if so, did you use it recently to roll back your config.

Inversely you could back up your sequences and reinstall LOR.

Link to comment
Share on other sites

LightORamaDan wrote:

If you are still having the problem, re-install the software.

This is what I had to do, I have no idea what happened, I haven't installed anything new on this pc, or done any reverts
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...