CHANNEL LOCKED ON

[Talons]

I have two showtime controllers and only one channel is constantly locked on and I have read about the reset procedures but things have to be black and white with me..lol. So I have disconnected the power but do not know where to reset the ID switches to zero zero, assuming I have the proper procedure for this model. I have a showtime controller in a metal container and it has a red LED light but not LED displays. I need dummy proof instructions to reset this controller....HELP PLEASE.

[jimswinder]

you don't say what Model you have..sooo...

To reset the 1600 series:

Remove power

Turn the dials to 00

Reapply power for approx 10 secs

Remove power

Reset the dials to the correct ID number

Reapply power

　

To reset the PC series: Gen 1 and Gen 2 Boards

Remove power

Remove the jumper from the 2nd row on the header

Reapply power for approx 10 sec

Remove power

Replace the jumper

Reapply power

Reset the controller to the correct ID number

To reset the Gen 3 series PC boards:

Remove Power

Remove the jumper from 4 & 5 over to 5 & 6,

Restore Power

LED starts flashing fast.

Remove Power

Move jumper back to 4 & 5

Reapply Power

Then open the Hardware utility and reset Unit ID

To Reset the CMB-16 DC series:

Remove power

Turn the dials to 00

Reapply power for approx 10 secs

Remove power

Reset the dials to the correct ID number

Reapply power

To Reset the iDMX-1000:

Remove Power

Hold down the Select button and power the iDMX-1000 on

The StatusLED will blink rapidly.

Once it starts blinking rapidly,

release the Select button and the unit will

run normally.

[Talons]

Thank you, not sure which model but I really appreciate your help MERRY CHRISTMAS

[T34 Flyer]

I have a Gen 3 controller with channel 7 stuck on.  I have tried the remedy as stated above to no
avail.  Can anyone think of another approach before I send this in for TRIAC replacement? 

Thanks everyone.