Jump to content

Hardware utility wont find 0D


friskybri
 Share

Recommended Posts

I was in Hardware utility and it wont find Unit 0D. I went to the controller and the led light is steady. I tried restarting the pc, unplugged the unit and replugged it back in to see if that would work. When the sequence is played it plays as normal but the hardware utility cant find it. I keep refreshing but it still wont pop up. I have 3.8.0 advanced. I wouldn't think it would be the cat 5 because the unit behind it is found.

Edited by friskybri
Link to comment
Share on other sites

Ok that is weird. After a hour or so I tried again and now it found it, then refreshed a few times again and now its gone for the past 4 refreshes. THis is very odd.

Edited by friskybri
Link to comment
Share on other sites

Did you assign a unit ID # to each controller? In your HU at the left lower screen is where you can assign the controller. I made the same mistake just recently.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...