Jump to content

Controller Not Working During Sequence


Chino Lights
 Share

Recommended Posts

I have 3 controllers. They are all set up with their propper unit numbers. Controller number 3 is not working during the sequence. When I test the unit, the lights come on, but when I run the sequence, they do not. All channels appear to be set up correctly per the channel property grid.

Any ideas? I've tried everything I can think of.

Link to comment
Share on other sites

In your channel property grid, is controller #3 show device type Light O Rama Controller, Network regular, and your unit number as 3 and then your channels numbered as you want them? I know I have seen that happen on my own stuff sometimes. Also make sure there are no duplications between your controllers in your channel configuration.

Link to comment
Share on other sites

What license level are you running? Basic would limit you to two controllers. You'll need Basic Plus license or higher to run more than two controllers.

  • Like 1
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...