overeazy Posted November 29, 2012 Share Posted November 29, 2012 Ok just got my CCRs all hooked up. Went to the hardware utility and it found all six of them. Losed it and went out to close up the box I have them in and notice that all of the units have one solid red light and the other one is blinking on and off. Is that normal? Or am I just use to seeing the LOR boxes with a steady red light when all is well. And if it is not normal any ideas what might be wrong then.thanks Link to comment Share on other sites More sharing options...
George Simmons Posted November 29, 2012 Share Posted November 29, 2012 (edited) The blinking light means no communication with the network. Edited November 29, 2012 by George Simmons Link to comment Share on other sites More sharing options...
overeazy Posted November 29, 2012 Author Share Posted November 29, 2012 Could that be because at the time I had yet to go into the LOR sequencer and set my Aux networks up for the right comm ports. I just happen to notice that I had not done that yet and just did it. Wondering if that might have been my problem. Link to comment Share on other sites More sharing options...
George Simmons Posted November 29, 2012 Share Posted November 29, 2012 I'll bet you've found the problem. Link to comment Share on other sites More sharing options...
overeazy Posted December 2, 2012 Author Share Posted December 2, 2012 Well the problem was that the ccr's are on 2 aux networks but I didn't have my main network plugged in. Once I hooked the main network up first then all was well. Link to comment Share on other sites More sharing options...
Recommended Posts