Jump to content

Question on X10 closing sequence


msturtz
 Share

Recommended Posts

I found somebody selling the CM11A on ebay for $22 with free shipping, so I ordered one. Hope it gets here soon.

I want to set up my porch lights (4 total fixtures, that are typically on all night via a photo sensor) to shut off durring the show, except I have a filler sequence that I'll turn them on for. After the show, I want them left on until morning.

The electrical I have covered I'll make it so a button on my X10 controller does the right thing.

What's the best way to accomplish what I want in the LOR software? I started out making a "After Hours" animation sequence, putting it in an "after hours" show, and then I was going to set that show to run after the main show ends. Is there an easier way?

-Matt-

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...