kj11856 Posted November 21, 2012 Share Posted November 21, 2012 I have 2 CCRs. one controller is lighting up half of the ribbon without commands. I have unplugged it and plugged it back in. I reloaded the firmware and did a reset on the controller. Is the CCR controller bad? Link to comment Share on other sites More sharing options...
steve synek Posted November 22, 2012 Share Posted November 22, 2012 You say you have two. Try a swap with the working ribbon and see if the same ribbon is acting up or if it's the controller.Steve Link to comment Share on other sites More sharing options...
keithheit Posted December 5, 2012 Share Posted December 5, 2012 I am having the same issues with one of my ribbons. I switch out the controller with a back up and no change. Did you get yours to work?? Thanks for any guidance.Keith in Denver Link to comment Share on other sites More sharing options...
rwertz Posted December 5, 2012 Share Posted December 5, 2012 Make sure the Unit ID mode isn’t set to Legacyhttp://www.lightoram...uring_units.htm Link to comment Share on other sites More sharing options...
keithheit Posted December 5, 2012 Share Posted December 5, 2012 Both controllers (Original and backup) are set in Normal ID mode and Triples in Channel Mode. Link to comment Share on other sites More sharing options...
Recommended Posts