nicksullivan Posted November 19, 2012 Posted November 19, 2012 Ok so it was working fine. I had all 3 controllers linked up and working. Now one of them only can be seen by the hardware utility only and can't see the other 2 controllers. I think this is what happened. I noticed one of the channels was dead. I unplugged the wire on the board to see if it was the problem. then pushed it back on. Since then the controller wont see the other controllers? I tried reflashing the firmware but no luck.... Any ideas? I swapped out the cable too and nothing. It runs fine if I use the telephone cable to it directly but it doesnt see the other controllers.Any help would be appreciated.N
EvilM0nkey Posted November 20, 2012 Posted November 20, 2012 Since you were inside the one, the #1 thing I would do is give it a second close look. Make sure you didn't knock anything else loose by accident. What's the LED inside doing while this is happening?
Recommended Posts