craigsrobotics Posted November 17, 2012 Posted November 17, 2012 I have the MP3 show director on one 16 channel pro controller, and another 16 channel addon controller. They have been pre-set by the factory and the sequences have been programmed for me already. Upon watching the show, it seems that the same number channel on both controllers is doing the same thing. The show director controller reads "1-xx" where xx is the current song, and the slave controller reads "L-01". Im assuming this is correct since it was "precanned' by LOR for me. Is it possible they programmed the 16 channel sequences and not 32?
Tim Fischer Posted November 17, 2012 Posted November 17, 2012 Sounds like both controllers are set to be Unit 1. You need to set the second controller to be Unit #2.
craigsrobotics Posted November 17, 2012 Author Posted November 17, 2012 So that it should read "L-02" ?
craigsrobotics Posted November 17, 2012 Author Posted November 17, 2012 Ok thanks...changed it, rebooted the controllers, doing same thing....every now and then they look as if they ARE doing something different, but not too ofter per song....Can someone tell me if the pre-canned sequence packages 1 & 2 should be paralleling the channels on each controller? I've only got lights connected to channel 1 on each controller for a test, then changed to channel 4 on each controller, and throughout most of the sequences, it looks as if they're operating in parallel...May just be the way they're programmed, maybe?
craigsrobotics Posted November 17, 2012 Author Posted November 17, 2012 Nevermind...thanks everyone..seems to be in the sequence programming...it's working fine...LOL...sorry I panicked....
Recommended Posts