Jump to content
Light-O-Rama Forums

Error code


electroman

Recommended Posts

Have you installed the drivers for the USB485 adapter?

Do you have the USB485 plugged in when you open the Hardware Utility?

Link to comment
Share on other sites

  • 4 weeks later...

yes and yes but i still got the error 8002

show can not be enabled because of an error. Open of serial port has failed.

error ( 8002) com port error

While: Open COM1 params baud=57600 parity=n data=8 stop=1 xon=off

odsr=off dtr=off rts=off idsr=off

While: Open COM1 params baud=57600 parity=n data=8 stop=1 xon=off

odsr=off dtr=off rts=off idsr=off

Trace: Init Light-O-Rama port/LOR Channel IO

what did or didnt i do? and how can i fix this?

Please help

Thanks

Dennis

Link to comment
Share on other sites

Don has it right, one of your controllers or your USB485 are not properly setup or installed when the show starts. Open verifier and see whats not happening.

Edited by GoofyGuy
Link to comment
Share on other sites

I have the same 8002 error code. Hardware Utilities found my controller okay and test console works both my controller and my CCR. I have successfully downloaded sequences and set showtimes. Just cannot enable shows to run. I have everything running in test mode just so I have lights on. Please help

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...