viennaxmas Posted September 21, 2012 Share Posted September 21, 2012 Quick question on triggers (Gen3 CTB board): Is there a way to switch from NO to NC? As a background: I want to connect a motion sensor to start a show and most of them are operating in NC mode, meaning that the contact is closed and does open when motion is detected. I did check the manuals and have not seen any option to change it.Thanks! Link to comment Share on other sites More sharing options...
KStatefan Posted September 21, 2012 Share Posted September 21, 2012 You could add a relay to the circuit. Link to comment Share on other sites More sharing options...
Aaron Maue Posted September 21, 2012 Share Posted September 21, 2012 Via the hardware utility, you can set each of the inputs to NO or NC. I'm going from memory, but I think you can click the Configure button at the bottom of the control tab of the hardware utility. There, you should see some check boxes to change the input type. 1 Link to comment Share on other sites More sharing options...
viennaxmas Posted September 21, 2012 Author Share Posted September 21, 2012 Thanks Aaron! If this does not work I will go the relay route... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now