oj70chevy Posted May 6, 2012 Share Posted May 6, 2012 Is there any way to color mix 5050 RGBs hooked up to A CMB-16D-QC? And when adding it to an existing controller under add controller would it just be set as light-o-rama controller or Digital IO card?Thanks for your helpRalph Link to comment Share on other sites More sharing options...
Guest guest Posted May 6, 2012 Share Posted May 6, 2012 Set it as a controller.You'll use one channel per color, so 3 total, red, green, blue, for the strip, and adjust intensity per channel to mix colors. Link to comment Share on other sites More sharing options...
oj70chevy Posted May 6, 2012 Author Share Posted May 6, 2012 Great thanks. I found a web page for color mixing and give it a try then I get everything in. Thanks again Link to comment Share on other sites More sharing options...
Dave H1 Posted May 7, 2012 Share Posted May 7, 2012 try this one alsohttp://www.rapidtables.com/web/color/RGB_Color.htm Link to comment Share on other sites More sharing options...
Guest guest Posted May 7, 2012 Share Posted May 7, 2012 or go here: http://www.seasonalentertainmentllc.com/downloads.htmlook under tutorials and download the doc on RGB Programming. It will give you some of the basics on the software side. Link to comment Share on other sites More sharing options...
oj70chevy Posted May 7, 2012 Author Share Posted May 7, 2012 Dave that is a way better page then the one I was looking at. Don hits the home run. very nice page with a lot of information and just what i needed. Link to comment Share on other sites More sharing options...
Recommended Posts