Jump to content
Light-O-Rama Forums

CTB08v3... pulling my hair out


Recommended Posts

Does anyone have a manual for CTB08 v3 boards? I am having a fit trying to use two, everything else in my network is CTB16PC's. The led goes solid when connected to the network, if I plug an ethernet cable directly into the board with my laptop and run hardware utility, it is found just fine.. but when I plug it into the rest of the controllers it cannot be found.

Unlike the CTB08 manual on the LOR site, these are v3 and have two blocks of jumpers that say COM and Input... I suspect I may need to do something with those, but the only manual on the LOR site is the CTB08 with a single jumper on input..


Link to comment
Share on other sites

This topic is now closed to further replies.
  • Create New...