RaceMedic Posted November 19, 2011 Share Posted November 19, 2011 Quick question .. from a lack of experience.I have one of those small input trigger cards that I have installed in one of my controllers to launch my show.After the first night I do not need it.Can I simply removed the wires going to the trigger button and have the card attached in the controller for the rest of the season or does it need to be removed.Thank-you for your time !Dave Link to comment Share on other sites More sharing options...
-klb- Posted November 19, 2011 Share Posted November 19, 2011 As long as you are setting it up as normally open, you can disconnect the wires at will. Link to comment Share on other sites More sharing options...
RaceMedic Posted November 20, 2011 Author Share Posted November 20, 2011 -klb- wrote: As long as you are setting it up as normally open, you can disconnect the wires at will.How would you go about doing that ... in the hardware settings ?! Link to comment Share on other sites More sharing options...
JBullard Posted November 20, 2011 Share Posted November 20, 2011 RaceMedic wrote:-klb- wrote: As long as you are setting it up as normally open, you can disconnect the wires at will.How would you go about doing that ... in the hardware settings ?!yes Link to comment Share on other sites More sharing options...
cmoore60 Posted November 20, 2011 Share Posted November 20, 2011 As far as that goes. If the switch was configured as Normally Open (contacts close to make something happen) You can just remove the headed board with no problem. Unless your board requires the little jumper for the device ID setting.Chuck Link to comment Share on other sites More sharing options...
Recommended Posts